Reduced Emissions - NEC MultiSync E1100 Manual Del Usuario

Introduction
emissions and reduced air conditioning costs of the work environment.
The IPM System increases the monitor's life and saves energy and costs
by powering down when not in use.
MultiSync monitors follow the Video Electronics Standard Association
(VESA) approved DPMS power-down signalling method. VESA's
Display Power Management Signalling (DPMS) method, which is
endorsed by the EPA, is the power-down process a system should use to
communicate to the monitor to save power. Power-down functions can
be utilised only with an Energy Star system or video card which adheres
to the VESA DPMS standard. By using the monitor's horizontal and
vertical SYNC signals, the monitor can be prompted into the different
IPM modes. The following is the description of the LED indicator for
the IPM power-saving modes:
Mode
On
Stand By
Suspend
Off (IPM Mode) Orange
Off (Power
Switch, Off)

Reduced Emissions

The E1100 monitor incorporates Reduced Magnetic Field technology
designed to reduce magnetic and alternating electric field emissions and static
electricity. NEC's monitors follow the strictest magnetic field, alternating
electric field, and electrostatic recommendations of the Swedish Board for
Technical Accreditation, or SWEDAC (previously known as MPR, National
Board for Measurement and Testing). The JC-2144UMB follows the
recommendations of the TCO which specify maximum recommended values
of electric and magnetic fields.
LED Indicator
Green
Green
Yellow
No Light
Power Saving
None
Minimum (Quickest Recovery)
Moderate (< 15 Watts, Moderate
Recovery)
Maximum (< 5 Watts, Slow Recovery)
No Power Used (Fully Off)
E - 3