Hapro Luxura X5 Manual página 12

Reading the hour counters and software versions
Status menu
Hold the , and buttons for 5 seconds.
You now see the 'Quick status menu' .
The hour counters and software versions can be viewed here.
Resetting the hour counters
Navigate to '2. Lamp hours' or '3. Facial tanner hours' and press
Enter the PIN code and press .
The hour counters are reset.
Maintenance
Cleaning
The sunbed is equipped with a touch panel control. To prevent accidental operation of the
machine during cleaning, you can temporarily switch o the control. It is also recommended
that you temporarily switch o the control before you open the acrylic screen canopy.
Hold and for 5 seconds.
The display shows the remaining time + 'Cleaning' . During this period the display cannot be
operated.
The time you have to clean the machine can be changed. The standard cleaning time is 1
minute.
Cleaning the air conditioning (option)
Clean the air conditioning as explained in the instructions that accompanied your air
conditioning unit.
You must reset the service date after cleaning.
To reset the service date while a fault message is displayed, press
status menu' . From the standby screen, hold the
the 'Quick status menu' .
Navigate to 'Airco service date' and press
Enter the PIN code and press .
The airco service date is increased by 6 months.
Replacing the Qsens (option) liquid jug
Never re ll your Qsens liquid jug with regular tap water or any other liquid. Replace with an
original Hapro Qsens liquid jug. Remember to order the Qsens liquid jugs in time.
Before Qsens can be used for the rst time or after replacement of the liquid jug, the system
must be bled of air.
Hold the , and buttons for 10 seconds.
Enter the PIN code; it is set to 0000 by default. Press O to con rm. You are now in the
parameter menu.
Navigate to '09 - Qsens' and press
Navigate to '03 - Qsens initialization' and press
Press to start the initialization.
Wait until the Qsens nozzles produce a ne mist of water.
Press to stop the initialization.
Press to exit the parameter menu. Your Qsens set is now ready for use.
12
.
to enter the 'Quick
, and buttons for 5 seconds to enter
.
.
.
Unit status
00:43
1. Unit hours
2. Lamp hours
3. Facial tanner hours
4. Airco service date 01-01-2012
Display software
Display pictures
Switch board
I/O Controller
Sens controller
Cleaning
Ventilation board
00:43
Cleaning
Unit status
00:43
1. Unit hours
2. Lamp hours
3. Facial tanner hours
4. Airco service date 01-01-2012
Display software
Display pictures
Switch board
I/O Controller
Sens controller
Cleaning
Ventilation board
2461
>
237
237
5.4
2.3
2.3
1.0
1.0
3.0
2461
237
237
>
5.4
2.3
2.3
1.0
1.0
3.0