Installation - Omcan HP-CN-0035 Manual De Instrucciones

and inspected prior to shipment. When accepted for delivery by carrier, the responsibility for safe arrival at the
destination is assumed by the carrier. The universal runners are boxed separately and found inside the cabinet.
CAUTION: Should any damage be found, do not attempt to operate the unit. Call your dealer
IMMEDIATELY to arrange for service.
Position your unit on a stable level surface and plug in the supplied cord into any grounded 120-volt AC, 15
amps power supply dedicated breaker. It does not require a dedicated circuit but is designed for use with the
power cord supplied with the unit. It is highly recommended that you use ONLY the power cord supplied. Use
of a dedicated circuit should insure operational efficiency. Do not operate the unit with an extension cord.
UNIVERSAL RUNNER ASSEMBLY INSTRUCTIONS
RUNNER ASSEMBLY PROCEDURE
RUNNERS MUST BE ASSEMBLED WITH A 4" MINIMUM SPACE ABOVE THEM TO ASSEMBLE THE
RUNNER
1. Grasp the runner.
2. Tilt the runner up while holding both ends together. Insert both ends of the runner in the wall bracket. Do
not have one side inserted unless the other is in place.
3. Tilt the runner down into position applying a slight force inward against the runner and cabinet. Do not
force.
4. When in the correct position the runner should be at 90 degrees to the side of the cabinet.
1 2
5

Installation

3 4