Bresser 88-31000 Instrucciones De Uso página 21

about 3 seconds.
the arrows are blinking and
the display reads "CAL."
It's best to place the com-
pass on a flat surface and
turn it two times in a clock-
wise direction. After this,
press the „Compass" button
again.
The signs "OP" and "0º" are now displayed in the
middle. When you push the "Compass" button
once more, the calibration is complete and the
compass is working.
You can also calibrate the compass on the palm of
your hand while holding it as horizontal as possi-
ble. The level directly over the „Compass" button
can help you while doing this. The compass is lying
horizontally when the air bubble is located inside
the tiny red ring in the middle.
All manuals and user guides at all-guides.com
Now all Other Compass Functions
The Thermometer
Your compass can also show you the temperature.
With the "ºF/ºC" button you can select which unit of
temperature to use. Normally for us, the º Celsius
is used.
In some countries, º Fahrenheit is used.
By pressing the "ºF/ºC" button, you can switch be-
tween the two.
Important! If you want to measure the external tem-
perature, make sure that your body heat does not
influence the measurement result.
The Stopwatch
Your compass also has a stopwatch. To use this,
press the "Second" button (No. 1) on the top of the
compass once. The stopwatch is now activated.
With the "Second" button, you can start and stop
recording the time by pressing it again.
In order to reset the stopwatch to zero, press the
"Count" button next to the "Second" button.
Press the "Set" button to go back to normal mode.
GB
21