IKEA BEKANT Manual De Instrucciones página 4

ENGLISH
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the
appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
Advice and instructions
for BEKANT sit/stand desk.
Sound level: lower than 55 dB(A)
Height setting interval:
EU-version: 64-125 cm
NA-version: 57,4-122,4 cm/22,6-48,2 inch
Maximum load: 70 kg/154 lbs
Temperature interval at usage:
41 up to 104 degrees Fahreheit
Temperature interval at storage:
14 up to 122 degrees Fahreheit
Humidity:
20% up to 80% at 86 degrees Fahrenheit.
Every person who is responsible for this
table at installation or employment of
the table in daily use or in service and
repair work should carefully read these
instructions. Keep these instructions close
to your sit/stand table.
This appliance shall only be used together
with the included power supply unit.
Installation instructions
— The table is assembled according to
separate assembly instructions.
— Connect the cable from one leg to the
other. Connect the hand control to one
of the leg and the power-supply to the
other leg. The cables to the legs, hand
control and power supply should be
placed in the accompanying net. Place
the electrical cables so that they do not
get damaged, see assembly instruction.
— Connect the electrical cable to a wall
socket.
NB! The electrical cable must have full
mobility.
— Insert the safety key in the socket on the
hand control.
— The table is now ready for use. The
motors stop automatically when the
table reaches its lowest and highest
position respectively.
Usage of the table
— The table shall only be used as a working
table with the possibility to continuously
adjust working height between sitting
and standing position. The table shall
only be used indoors and in dry premises
(office environment or similar).
— The table must not be overloaded -
maximum load is 70 kg. The motors
may be run continuously for maximum
1 minutes. Afterward, the motors must
stand by for approx. 9 minutes before
they can be used again.
Follow these instructions when
adjusting table height:
1. Insert the safety key in the socket on the
hand control.
2. Make sure no objects are in the way of
the table adjusting height freely.
3. In order to run the table up/down, press
the manoeuvre button with an arrow
pointing up and down respectively.
4