Sunex Tools 1501 Manual Del Propietário

WARNING INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THESE STANDS, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING PROCEDURES,
SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these stands. It is also the responsibility of
the stand owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or
not legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of wheel dollies is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise of intelligence,
care, and common sense. It is essential to have personnel involved in the use and operation of the dolly who are careful, competent, trained,
and qualified in the safe operation of the dolly and its proper use when working on wheel and tire assemblies. Examples of hazards are
dropping or slipping of load, caused by improperly securing loads, overloading, off-centered loads, and improper setups.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand & follow all instructions before using.
• Inspect the Wheel Dolly before each use. Do not use if damaged, altered, modified, in poor condition or unstable due to loose or
missing components. Make corrections before using.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Do not exceed rated capacity.
• Use only on a hard, level, dry concrete surface capable of supporting the load and free from all obstructions.
• Before moving, lower the load to the lowest possible point.
• Apply load as close to the verticle portion of the lifting member as possible.
• Before moving the load, ensure the load is centered and secured with a load-restraint device.
• No alterations shall be made to this device.
• The use of this wheel dolly is limited to the removal, transportation, and installation of wheel assemblies.
• Adequately support the vehicle before starting repairs.
• Always keep hands off vertical guide post when lowering elevator.
• Do not lift or support vehicle with wheel dolly.
• Do not use with tandem and duplex wheel and tire combinations.
• Do not start the vehicle's engine or drive the vehicle when removing or installing wheel/tire combinations with a wheel dolly.
• When transporting a load, be sure not to make any sudden or abrupt stops as this may cause the telescopic lift arm assembly
to extend.
• Only attachments and/or adapters supplied by the manufacturer shall be use.
• Failure to heed these warnings may result in fatal personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS could
cause accidents resulting in serious or fatal personal injury and/or property damage.
1501 Rev. A
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
CAPACITY: 1,500 LBS.
HYDRAULIC WHEEL DOLLY
WARNING: Indicates a hazardous situation
WARNING
which, if not avoided, could result in death
or serious injury.
1
1501 Rev. A
rev. 3/9/20