Important Safety Instructions - Teac LS-WH01 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS

CAUTION
o DO NOT REMOVE THE EXTERNAL CASES OR
CABINETS TO EXPOSE THE ELECTRONICS .
NO USER SERVICEABLE PARTS ARE INSIDE .
o IF YOU ARE EXPERIENCING PROBLEMS
WITH THIS PRODUCT, CONTACT THE STORE
WHERE YOU PURCHASED THE UNIT FOR
A SERVICE REFERRAL . DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED .
o USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE .
IN USA/CANADA, USE ONLY ON 120 V
SUPPLY.
2
Model for USA
This device complies with part 15 of the
FCC Rules . Operation is subject to the fol-
lowing two conditions: (1) This device may
not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation .
CAUTION
Changes or modifications to this equip-
ment not expressly approved by TEAC
CORPORATION for compliance will void the
user's warranty .
This equipment has been tested and found
to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC
Rules . These limits are designed to provide
reasonable protection against harmful
interference in a residential installation . This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications . However, there is no
guarantee that interference will not occur
in a particular installation . If this equipment
does cause harmful interference to radio or
television reception, which can be deter-
mined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the equipment and/or
the receiving antenna .
• Increase the separation between the
equipment and receiver .
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected .
• Consult the dealer or an experienced
radio/TV technician for help .

Publicidad

Tabla de contenido
loading

Tabla de contenido