English - Atlantis Land A02-RA241-W54 Guia De Inicio Rapido

For more detailed instructions on configuring and using
the Wireless Router ADSL2+, please refer to the online
manual.
Before beginning the configuration of the Router you have to
know the parameters of your subscription ADSL.
There are four ways ─ PPPoE, PPPoA, RFC1483 routed,
RFC1483 Bridge─ for the device to have a public IP address
and then to access Internet. You have to check with your
ISP about which way is adopted.
VPI/VCI: Consult the telephone company to get the Virtual
Path Identifier (VPI) and Virtual Channel Identifier (VCI)
numbers. The valid range for the VPI is 0 to 255 and for the
VCI is 32 to 65535. The default value VPI is 0 and VCI is 32.
For BT (VPI=0, VCI=38)
NAT: The NAT feature allows multiple-user Internet access
for the cost of a single IP account. If you need to have a
public server or a public network, NAT has to be disabled.
Encapsulation Method: Be sure to use the encapsulation
method (LLC/SNAP or VC MUX) required by your ISP.
Gather the information as illustrated in the following table
and keep it for reference.
PPPoE
PPPoA
RFC1483
Bridged
and for KC (VPI=1, VCI=50).
VPI and VCI
VC-based / LLC-based multiplexing
Username and Password
Service Name
VPI and VCI
VC-based / LLC-based multiplexing
Username and Password
VPI/VCI
VC-based / LLC-based multiplexing

ENGLISH

21