Funcionamiento; Instalación De Las Pilas - SP scienceware H-B DURAC B60911-0100 Manual Del Usuario

Select Graphs to Display
General Setting Page
On the opening page in the app, press the [Setting] button (
2
To register this product for a one-year limited warranty, visit www.belart.com/warranty
Termómetro DURAC
Termómetro e higrómetro DURAC
Este termómetro/termómetro-higrómetro funciona con dispositivos o teléfonos móviles que tengan instalados los sistemas operativos iOS7+ o
Android 4.3+ y Bluetooth 4.0. Antes de utilizarlo, asegúrese de que las funciones de Bluetooth, alarmas y notificaciones estén activadas.
Esta unidad lleva integrada la tecnología Bluetooth Smart, por tanto no es necesario emparejar los dispositivos.

FUNCIONAMIENTO

Descargue e instale la aplicación Thermsmart desde la App Store o Play Store antes de comenzar.
INSTALACIÓN DE LAS PILAS
Utilice un destornillador para abrir la tapa de las pilas
Inserte 2 pilas AAA respetando la polaridad correcta
Utilice un destornillador para cerrar la tapa de las pilas
Si las pilas se colocan correctamente, el dispositivo se encenderá automáticamente y la luz LED brillará intermitentemente. Esto es para recordarle
que es necesario sincronizar la hora del dispositivo con la de su teléfono; sin embargo, antes de sincronizar la hora debe registrar el dispositivo.
To display as a graph press the [Select Plot] button (1).
A maximum of 6 sets of data from different units can be viewed in one graph.
2
Export Graph
1
To export the graph in pdf format and send it by email,
press the [Export] button (2).
Zoom and Shift
To zoom in or out, 'pinch' the View Area (3) together
to zoom in or 'spread apart' to zoom out.
Data Read Out
To read the specific data on the graph, drag line to the desired point
3
in the graph and read the data displayed on the top of the graph.
) to enter into the General Setting Page. The following can be done.
Change Temperature Unit
Press the [Celsius] or [Fahrenheit] button to change the temperature unit.
Clear All Downloaded Data
To clear the downloaded data from all units, press the [Reset All Data] button
(2). Clearing all downloaded data will not clear the data saved in the unit only
on the mobile device or phone. To clear the data off the unit, turn off the unit.
Turn the unit On/Off
Unless it will be idle for an extended period of time, the unit should
not be turned off. If turning off is desired, press and hold the [On/Off] button
on the back of the device. When the LED light starts to flash,
1
release the button. The device is off when the LED light stops flashing.
NOTE
Before turning off the unit or changing batteries, download data
stored in the unit to the mobile device or phone as the data saved
in the unit will be cleared.
When the unit is turned again the LED light will flash. The device will
need to be synchronized with the mobile device or phone.
This time sync procedure is needed every time the device is turned on.
If a malfunction occurs in the app because of interference,
close the app and reopen it.
® con Bluetooth y registro de datos de 30 días (B60911-0100)
® con Bluetooth y registro de datos de 30 días (B61506-5100)
ESPANOL
5