Carburettor Exchange / Inspection - Trueshopping MFS260C Manual Del Usuario

•
If cleaning the filter, inspect for and
brush off any debris. Then clean in
warm soapy water and allow to fully
dry before putting it back onto the
machine
•
If replacing, discard the old foam filter
and fit the replacement in its place.
*To help prevent fine dust particles
from entering the engine add a few
drops of motor oil to the foam filter
and scrunch it up in your hand before
replacing.
•
Finally, replace the air filter
cover and fasten it back into
position.

Carburettor exchange / inspection

The following procedure will show you how
to remove your carburettor and either
exchange or inspect it for problems
• The carburettor is accessed by
removing the screw or unfastening the
plastic fastener (model dependant) as
circled below.
19