Intended Use; Product Description - Quick LDIM BUS RGBW Manual De Instalacion Y Uso

CHARACTERISTICS / INSTALLATION
EN

INTENDED USE

• This device is designed to control the intensity of LED lighting in marine applications.
• Once connected to the system (i.e., to the power supply, the lights, the buttons and/or the serial line), the dimmer pack
lets you turn on, turn off or adjust the intensity of 4 lines (channels) of LED lighting, using either the buttons or the serial
line.
• For fire-prevention reasons, install the dimmer pack in a ventilated, controlled-temperature environment, protected from
dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Any other use should be considered improper and unpredictable.
F
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE DIMMER PACK. IN CASE OF DOUBT, CONTACT
YOUR DEALER OR QUICK
THE PACKAGE CONAINS: RGBW dimmer - conditions of warranty - the manual of installation and use.

PRODUCT DESCRIPTION

The dimmer lets you change the intensity of 4 channels of LED lights independently, using the 4 respective inputs (but-
tons) or the serial line.
Each channel is protected and can handle a maximum current of 6 A.
The unit's operation is shown by the input, output and power supply LEDs (see Alerts/Diagnostics Table, page 13).
The operating mode can be selected using the DIP switches.
Adjusting the intensity of the LED lights can be done in two ways, selectable by DIP switch:
• Local operation, using button inputs.
• Remote operation, using the Modbus serial line.
The light source can be of three kinds, selectable by DIP switch:
• single-colour light (4 independent channels);
• tunable white light (2 independent channels);
• RGBW light (1 channel resulting by mixing the individual colours).
INSTALLATION
• The dimmer pack can be easily mounted on a DIN rail. Install the device on a vertical surface for better ventilation.
• Install the dimmer pack inside a power distribution panel, adequately protected so that,
- the device works in the required operating conditions
- the device cannot be accessed by unauthorized personnel.
• Always disconnect the power supply when installing or servicing the dimmer pack.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the dimmer pack.
• Disconnectable terminals make it easy to replace the device.
• Turn on the power, MAKE SURE THE POLARITY IS RIGHT, make sure the CPU LED is flashing (which means the logic circuit
is powered) and that LEDs F1 and F2 are illuminated (which means the internal fuses are powered and working proper-
ly) (see Alerts/Diagnostics Table, page 13).
F ACCESS TO THE INTERIOR OF THE DEVICE IS ALLOWED ONLY TO PERSONS AUTHORIZED BY THE MANUFACTURER,
AND ONLY FOR THE FOLLOWING PURPOSES:
- REPLACING A BLOWN FUSE located inside the device.
- DOWNLOADING FIRMWARE by means of the utility connector located under the cover (this operation requires ded-
icated software and hardware).
CUSTOMER SERVICE.
®
10
DIMMER RGBW - REV005A
QUICK SPA