JVD Shield Instrucciones De Uso página 21

Changing the area
24/7 MODE
• MAINTENANCE/FAULTS
RED
INSTRUCTIONS FOR USE
1. Managing contamination
The appliance reduces the airborne microbial
load in order to limit contamination between
individuals during the airborne phase. The
2. Managing particles
If the appliance is in an environment with a high particle load over 2.5, the Core will need to be changed
more frequently.
Activating
the mode
being purified
Activating the
BOOST mode
Stopping 24/7
mode
Fast flash
Steady
Screen off
Press the CONTINUOUS button
Press for 3
seconds
During a 24/7 cycle, you can change
the area being treated. Select a new
area by pressing the desired button.
Press BOOST to start a shock
purification. At the end of the cycle,
the Shield will revert to 24/7 mode.
purification cycle is being performed.
The Shield will then await further
Press CONTINUOUS. The Shield will
start an 8-hour CONTINUOUS cycle.
MAINTENANCE - Your Core is at the end
of its lifespan. In this situation, your Shield
will still operate but will not provide optimal
purification performance. Contact your
distributor or our JVD teams to order a new
Core. Refer to the Maintenance tab.
FAILURE - A failure has been detected in your
appliance. In this situation, your Shield can no
longer operate. Contact the JVD helpline on
+33 (0)2 40 75 96 30.
Check your appliance's connections. If the
interface still does not light up, contact the
JVD helpline on +33 (0)2 40 75 96 30.
appliance does not protect against direct contact
contamination or spray projections. You should
continue your current cleaning procedures.
for at least 3 seconds.
Press HOME. This means no
instructions.
21