TP-Link RE450 Manual De Instalación Rápida página 8

NOTE: The product model shown in this QIG for Wireless Range Extender is "RE450",as an example.
LED Explanation
(RE)
Solid blue: The extender has established a secure
connection, and the signal strength is adequate.
Solid red: The extender has established a secure
connection, but the signal strength is too weak.
Blinking: WPS connection is in process.
Off: No active connection.
Button Explanation
LED button: To turn all LEDs on or off, press the LED button.
Power button: To turn on or off the extender, press the Power button.
Option 1: Using a Web Browser
Option 2: Using WPS (Wi-Fi Protected Setup)
Option 1 Using a Web Browser
① Power on
Plug the extender into an
electrical outlet near your
router, and wait until the
Power LED is lit and solid
blue.
③ Configure
1. Launch a web browser and type http://tplinkrepeater.net in the address field. Use admin (all lowercase) for
both Username and Password to log in.
If the log in window does not pop up, please refer to the FAQ > Q1.
2. Create a new username and password to log in the web management page, then click Confirm.
3. Select your country/region, then click Next.
2.4GHz/5GHz
On: The extender is connected to the 2.4GHz/5GHz
wireless network of your host network.
Off: No connection.
Power
On: The extender is on.
Blinking: The extender is initializing.
Off: The extender is off.
② Connect to the extender
via Ethernet Cable
1. Disable the Wi-Fi on your
computer.
2. Connect the extender to your
computer via an Ethernet
cable.
http://tplinkrepeater.net
admin
admin
Login
5
via Wireless
Not connected
or
Connections are available
Wireless Network Connection
TP-LINK_Extender_2.4/5GHz
Connect automatically
√
1. Disconnect the Ethernet
(wired) connection to your
computer.
2. Click the Wi-Fi icon on the
taskbar and connect to the
extender's network :
TP-LINK_Extender_2.4/5GHz
English
Connect