Setting Channels Into Memory - memorex MLT1912 Guia Del Usuario

SETTING CHANNELS INTO MEMORY

1
1
2
3
Press the STANDBY button 1 to turn on the TV; the
STANDBY indicator will turn off. Press the SOURCE button
2 to select the desired mode, TV (NTSC) or ATSC. Set the
desired reception mode (TV/CATV) as described on the
previous page. Press the MENU button 3; the Main Menu
screen will appear.
3
Select AUTO INSTALL using the CHANNEL/Navigation UP
1 or DOWN 2 button, then press the VOLUME
UP/Navigation Right button 3; the TV will automatically
cycle through all the channels and store active channels
into memory.
To Cancel AUTO INSTALL, press the MENU button 4.
NOTES:
• If no buttons are pressed for approx. 10 seconds, the menu will disappear automatically.
• Searching for ATSC channels may take 15 minutes or more to complete. A progress status is displayed while the channel
list is being created.
• The TV will only search for the NTSC channels while in TV (NTSC) mode or it will just search for ATSC channels while in
ATSC mode.
SETTING THE MENU (CONTINUED)
1
3
2
2
1
3
2
Select Setup using the CHANNEL/Navigation UP 1 or
DOWN 2 button, then press the VOLUME UP/Navigation
Right button 3 to select it. Select Preset using the
CHANNEL/Navigation UP 1 or DOWN 2 button, then
press the VOLUME UP/Navigation Right button 3 to
select it.
4
Press the MENU button repeatedly when finished or wait
approx. 10 seconds to exit the menus.
17