Placing Tool In Service - Ingersoll Rand 44SMA Manual De Funcionamiento Y Mantenimiento

LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
o
USA N . C31–06–G00
After each four hours of operation, unscrew the Oil
Chamber Plug and fill the Backhead with Ingersoll–Rand
No. 50 Oil.
Occasionally, squirt 2 or 3 drops of Ingersoll–Rand No. 50
Oil into the hole in the Throttle Sleeve.
Weekly, or as experience indicates, inject 2 or 3 strokes
(1 to 2 cc) of Ingersoll–Rand No. 28 Grease from the
No. P25–228 Grease Gun into each of the Grease Fittings.
Model
44SMA

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 28
HOW TO ORDER A LARGE DRILL
REVERSIBLE ROLL THROTTLE
Free Speed, rpm
155
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Capacity in Steel
Drilling
in. mm in.
2 51
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
Reaming Morse Taper Socket
mm
2 51 No. 4 Morse Taper