ScorpionExo ADX-1 Manual Tecnico página 6

EN
we recommend to place the parts in a washing bag. Do not place
lining parts in the dryer: Excess heat may damage the foam and
coverings. The faceshield may be cleaned with plastic polish or
mild soap and water. The shell of your helmet should be cleaned
using only a mild detergent and water.
Warning
For your safety, it is important that you completely read the
owner's manual and all warning labels.
DO NOT
DO NOT ride without snugly fastening your chinstrap.
DO NOT clean your helmet with petroleum products, solvents,
benzene, thinner or cleaning agents.
DO NOT paint over your helmet's finish without totally protecting
and isolating the shock-absorbing liner and plastic parts.
Your warranty will otherwise be invalidated.
DO NOT drop your helmet from any height onto a hard surface.
This could cause damage to your helmet's finished and/or
decrease its ability to protect you.
DO NOT place your helmet on your motorcycle's rearview mirror:
The sharp pressure from the mirror's edge will compress and
damage the helmet's shock-absorbing liner.
DO NOT place your helmet on the motorcycle's seat or fuel tank.
It can easily roll off and hit the ground causing damage to
the helmet. It is best to place your helmet on the ground so it
cannot fall in any direction.
DO NOT ride with a scratched faceshield. This can impair your
vision, especially at night.
DO NOT modify any part of your helmet, e.g., drilling the shell or
cutting and pressing the shock absorbing liner. Installation of
9
sound systems, speakers and microphones reduces your
helmet's ability to protect you and is not recommended.
DO NOT use the helmet again if it has either been dropped or
involved in an accident. Replace it even if the damage is not
visible to the naked eye.
DO NOT wear a dark or tinted faceshield (including the
retractable SpeedView Sunvisor) in dark or poor visibility
TM
riding conditions.
DO NOT place your headliners and cheek pads in the dryer after
washing. Allow them to air dry.
DO NOT attempt to remove, change or replace your faceshield
while riding your motorcycle or ATV.
DO NOT use paint which requires heat curing.
Warranty
All ScorpionExo™ helmets have a warranty of 5 years.
Although there is no visible damage on your helmet, general wear
and tear over time may affect overall function of protective helmet
and increase the risk of injury in accident. It is advisable to replace
your helmet no later than every 5 years from purchase.
Should you have a warranty claim, go to your Scorpion dealer with
your invoice (this is you purchase proof, it's necessary in order to
start the warranty process). You can find our dealers' list on your
website: http://www.scorpionsports.eu/english/dealers/find-a-dealer/
find-a-dealer.html (choose your country and then the location)
The dealer will contact our after sales service
and start the warranty process in order to check
and/or repair your helmet.
1 Visière aérodynamique
Visière rétractable et amovible. Conçue et optimisée pour une mobilité
maximale et permettre un passage aisé des flux d'air.
2 Ecran solaire Speedview®
Ecran solaire interne rétractable traité anti-buée. L'écran
solaire vous apportera un confort visuel en cas de
changement des conditions lumineuses sans vous obliger à
changer votre écran principal.
Pinlock® 100% MaxVision®
3
Ecran traité anti-rayures creusé et pré-percé pour intégrer la lentille
Pinlock® 100% MaxVision® (traitée anti-buée).
4 Revêtement KwikWick 2®
Très efficace, hypoallergénique, démontable, lavable en machine, très
doux et agréable au toucher, le revêtement intérieur KwikWick 2® de la
nouvelle gamme ScorpionExo® 2017 est un véritable chausson fait
sur-mesure pour votre tête.
5 KwikFit®
Le système KwikFit des mousses de joues permet l'utilisation
(insertion et retrait) aisée de vos lunettes.
6 Mentonnière relevable
Un bouton simple d'accès permet de relever ou abaisser la
mentonnière.
7 Système de Ventilation
Ventilations réglables, indexées à l'avant et à l'arrière pour une
circulation d'air maximale en été, une conservation maximale de
la chaleur en hiver.
Couvercles latéraux
8
Les couvercles latéraux donneront l'aspect d'un casque intégral. Ils sont
préinstallés sur votre casque et peuvent être remplacés par la visière
amovible.
1
7
2
3
5
4
7
6
8
2
FR
10