American Standard Cadet 2776.W Serie Instrucciones De Instalación página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WIR E SEL EC T IO N G U ID E
Moto r
Hi-Pe rfo ma n ce
Ra tin g
1 .1
DRAIN CONNECTION AND SYSTEM TEST
Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump
couplings and make sure they are hand-tight. Clean the whirlpool and fill with water to a point 2" above the top of the highest jet.
Recheck the pump couplings and make certain that they are not leaking. (Although the pump couplings are factory tightened and
inspected, some loosening may have occurred during transit.) Make sure the whirlpool is connected to the electrical supply and
turn the whirlpool on. Check for leaks around all piping connections while the whirlpool is running.
POST INSTALLATION CLEAN-UP
Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue depressor. Do not use
wire brushes or any other metal implement on bath surface.
Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains
may be removed using granular Spic and Span
Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.
FEATURES of YOUR NEW AMERICAN STANDARD ACRYLIC BATHTUB
Your new acrylic bathtub has been molded in the newest plumbing fixture material available today. Acrylics are tough durable
finishes that are simple and easy to care for.
The colors have been formulated to match other American Standard fixtures and enhance your choice of bathroom decorations.
The high gloss surface is resistant to impact and chemicals and will retain its lasting luster with proper care and maintenance.
AFTERCARE and CLEANING
• Always fill the tub with temperate water. Excessively hot water may cause surface damage
• Remove bath mat after use and hang to dry. Allowing bath mat to dry in the tub may cause surface damage.
• Clean after use with a mild liquid household detergent cleaner. Do not use Lestoil
Lysol
Basin, Tub and Tile Cleaner, Windex
®
HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.
• Do not use wire brushes, knives or sharp objects to remove stains, cigarette tar deposits, or other surface blemishes.
• Abrasive cleaners or powders must not be used, since they will dull the surface. If the glossy surface looses its sheen, dulled
areas can be restored by rubbing with a white "automotive type" polishing compound and waxing with a "liquid wax."
• Do not wax areas where you walk or stand.
• Do not allow nail polish remover, acetone, dry cleaning fluid, paint remover or other solvents to come into contact with the surface.
• Clean the surrounding surface immediately after using caustic drain cleaners.
• Burning cigarettes will damage the surface.
• Should damage to the fixture occur, repairs can be made quickly and easily.
Your distributor or builder can provide details.
M ax im u m d is tan ce from
f u s eb o x to mo tor
50'
10 0'
15 0'
1 15V P o we r L in e
12
1 2
10
mixed with water.
®
, Mr. Clean
, Dow
®
®
The sizes shown on this chart are
recommendations for copper
200 '
conductors only. Always follow
local and national electrical codes
8
, Lysol
®
®
Disinfectant Bathroom Cleaner, or cleaning products in aerosol cans.
®
SPIC AND SPAN ® IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE
(4)
Disinfectant (spray or concentrate), or
752561-100 Rev. F 1/19

Publicidad

Tabla de contenido
loading

Tabla de contenido