Assembly - Westpro WP2300 Manual Del Propietário

ASSEMBLY

Before assembling the pressure
washer, review Safety on page 7
and the following safety messages.
CAUTION
Never lift the pressure washer without
assistance. The pressure washer is
heavy and lifting without assistance
could result in personal injury.
Never use the handles as a lifting point
to support the entire weight of the
pressure washer. Only use the handles
to move the pressure washer by lifting
the handles and using the wheels to
move the pressure washer.
Use caution when collapsing the
handles. Hands and fi ngers could get
caught and pinched.
NOTICE
Assembling the pressure washer will require tipping
the unit. Make sure all engine oil and fuel are drained
from the unit prior to assembling.
Once assembled, the wheels are not intended for
on-road use. The wheels are designed for use on this
pressure washer only.
Never tip the pressure washer after it has been fully
assembled and fi lled with oil and fuel.
1. Place pressure washer
2. Place a piece of cardboard or other soft material to
tip the pressure washer
paint and prevent the
Tip the pressure washer
Figure 5.
on a fl at surface.
onto, to protect the frame
pressure washer from sliding.
onto the front as shown in
ASSEMBLY
Figure 5 – Tip the Pressure Washer onto the Front
3. Install the M12 x 105 mm wheel axle fl ange bolt
through the wheel (see Figure 6).
1
Figure 6 – Installing Outside Serrated Flange Nut
1 - Wheel Axle
Flange Bolt
4. Thread the M12 serrated fl ange nut onto the bolt
with serrated edges facing away from the wheel.
Tighten the nut (see Figure 6).
2
2 - Serrated Flange
Nut
13