Westpro WP2300 Manual Del Propietário página 15

10. Connect the wand to the spray gun and turn the
fi tting counterclockwise to tighten (see Figure 11).
Do not overtighten. The fi tting only needs to be
hand-tight.
1
Figure 11 – Connecting Spray Wand
1 - Spray Wand
11. Inspect the O-rings on both sides of the high-
pressure hose. Moisten the O-rings with water (see
Figure 12).
Figure 12 – High-Pressure Hose O-Rings
2
2 - Fitting
ASSEMBLY
12. Connect the high-pressure hose to the pump and
tighten the hose fi tting (see Figure 13). Do not
overtighten. The fi tting only needs to be hand-tight.
1
Figure 13 – Installing High-Pressure Hose
1 - Soap Hose
13. Connect the soap hose to the barbed fi tting if you
are going to be using soap (see Figure 13).
14. Flip the trigger lock up to lock the trigger in the OFF
position (see Figure 14).
1
Figure 14 – Trigger Lock in OFF Position
1 - Trigger Lock
15. Install the high-pressure hose to the spray gun
and tighten the hose fi tting (see Figure 14). Do not
overtighten. The fi tting only needs to be hand-tight.
2
2 - Hose Fitting
2
2 - Hose Fitting
15