Imetec BS2-100 Instrucciones De Uso página 19

• Plug the power adaptor (10) into a suitable power supply
and connect the charging lead into the charger connector
located on the rear cover of the charger stand (3) [Fig. B1]
• Slot the body shaver onto the charger stand (3) [Fig. B2].
The charging light (2) will be illuminated [Fig. B3]
• The charging light (2) does not go out or change colour
when the appliance is fully charged
• Do not keep the power adaptor (10) plugged into a wall
socket at all time. Always switch off and unplug the power
adaptor (10) after charging
• Examine the power adaptor (10) regularly for damage,
especially the cord, plug and enclosure; if the power
adaptor (10) is damaged, it must not be used until it has
been repaired
• Do not wind the power cord around the power adaptor (10);
instead roll it up loosely without bending it
To preserve the battery life of your body shaver:
• Do not recharge daily. Only recharge when the batteries run
out
• Do not charge the unit longer than the recommended
time. Over charging will reduce the life of the rechargeable
batteries
• Fully utilise the batteries every six months then recharge for
10 hours
• If the product is not going to be used for an extended period
of time, it must be recharged for 10 hours before storing
17