B) Installation With A Grommet Hole In The Desk - ONKRON G70 Guia Del Usuario

Soporte de escritorio brazo móvil (con el resorte de gas) para monitor individual
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30

b) Installation with a grommet hole in the desk:

Firstly disassemble C-Clamp (B) as shown on the picture. Attach part (J) to the tube
(E) using one bolt (H). Plastic cover (C) must be installed too. Put the clamp screw
(from disassembled part B) through part (I) and through the hole in the desk, and
then twist it in the tube (E), by spinning the knob. Key (L) may be used.
Make sure it is securely fixed on the table.
0-75mm
2.95"
Clamp
screw
5

Publicidad

Tabla de contenido
loading

Tabla de contenido