Belkin TuneDok Guia Del Usuario página 3

P74388ea-B_F8E467ea_man 10-11-2003 14:51 Page 2
How to Set Up the In-car iPod
EN
For automobiles:
1. Insert the In-car iPod holder flexible cup into the small, rigid cup.
2. Push the three snaps through the corresponding holes
in the bottom of the flexible cup. Make sure the two are
firmly connected.
3. Insert the In-car iPod holder cups into your car's
cup holder. Ensure that the arm of the cup holder
rests on top of the smaller cup's rim (Fig. 1).
The smaller cup keeps your
In-car iPod holder firmly in place.
To adjust the position of the iPod cradle:
1. Hold the In-car iPod holder flexible cup in one hand, and
the iPod cradle in the other.
2. Twist the cradle clockwise to lower it, or counterclockwise to raise it (Fig. 2).
Do not raise the cradle above the red line that's printed on the In-car iPod
holder stem, as it will make the In-car iPod holder unstable.
3. Place the In-car iPod holder into your car's cup holder.
4. Turn the iPod cradle toward you and make sure that its position allows you to
see and reach your iPod comfortably; adjust if necessary.
To attach the cable
of the Belkin Auto Kit:
1. Turn the In-car iPod holder
upside down.
2. On the underside, toward the front of
the iPod cradle, you'll find a cable snap.
3. Thread the Auto Kit cable through
here so it stays in place when you take
your iPod out of
the In-car iPod holder (Fig. 3).
™
holder
Fig. 1
Fig. 2
Fig. 3
2
To insert the iPod into the In-car iPod holder:
1. Make sure the suction cup is clear of dust
or dirt. If necessary, wipe it with a damp
cloth.
2. Take off anything that may be connected
to the dock connector.
3. Lay the dock connector end of the iPod
into the bottom of the iPod cradle and
gently push the iPod onto the suction cup.
4. Insert the Auto Kit connector into the dock
connector of the iPod through the iPod
cradle's bottom opening (Fig. 4).
For safety, always make sure that the In-car
iPod holder is securely resting inside your car's
To use In-car iPod holder as a desk stand:
1. Hold the cradle firmly in one hand, and the rubber
base in the other. Completely unscrew the Holder
from the rubber cup.
2. Flip the base upside down.
3. Insert the screw into the opening on the bottom
of the base, and twist clockwise. Make sure to turn
the screw until the red marker is fully inserted into
the base.
4. Adjust the height and angle to your liking.
Fig. 4
Fig. 5
3