Ahrend Mehes Manual página 30

8
10
12
Connections
Ahrend supplies various types of electrical sockets,
standard 3- or 4 gang, or with additional functions such
as a master/slave switch, high-voltage fuse and power
cleaner (fig. 8).
Fitting sockets
There are several different ways to fit a Mehes table
9
with system sockets.
The simplest method is to attach a socket directly to the
frame using a mounting clip (for 3-gang sockets) (fig. 9).
Hinged cable dumps
Cable dumps provide space in which the excess
length of equipment and power cables can be tidily
concealed. The system power sockets also fit in these
dumps (fig. 10).
There is a range of lengths, so that an appropriate
solution can be found in any situation. The number of
sockets that can be mounted in the dumps depends on
11
the type of socket and the length of the cable dump.
These dumps open on both sides for ease of access to
the cables in them (fig. 11).
Cable separators clicked into the bottom help to keep
cables tidy and separate (fig. 12).
Planning cabling
Position the cable dump as close as possible to the place
on the work surface where most of the equipment to be
connected is located.
29