RS Pro RS-9680 Manual De Instrucciones página 6

Particle Mass Concentration Detector / English
9-Settings
In measure page, long press SET/Up key to enter/exit settings page.
In settings page, short press Up/Down key to choose the item to be set and short press ON/OFF/
ENTER key to enter the submenu of item needed to be set. To exit from submenu, short press ON/
OFF/ENTER key to confirm all setting items then exit and back to the main menu of settings page.
9-1.Time Settings
Ability to set up hourly (12 hours or 24 hours), AM/PM, date and time. Short press Up/ Down key to
change time settings, and short press ON/OFF/ENTER key to confirm. After confirm all setting items
then exit and back to the main menu of settings page.
9-2.Measure Mode Settings(With WiFi Model is Able)
It is able to set up device's measure as regular measure mode or monitor measure mode, which
default is regular measure mode. In regular measure mode, device will auto power off.
In monitor measure mode, device will auto sleep so screen is off but measuring and uploading data is
continue.
9-3.Auto Power Off/Auto Sleep Settings
It is able to set up auto power off/auto sleep time as 10 to 120 minute or no auto power off/ auto
sleep. Device with Wi-Fi can set up auto power off time in regular measure mode or auto sleep time
in monitor measure mode.
8
9-4.Unit Settings
It is able to set up the unit of temperature as Celsius(°C) or Fahrenheit(°F), which default is Celsius.
9-5.Alarm Settings
It is able to set up the start point of PM2.5 alarm as 10ppm, 35ppm, 75ppm, 150ppm, 200ppm or
no alarm, which default is 35ppm. If PM2.5 alarm is enabled, device will beep when concentration
of PM2.5 is so high as to beyond the set start point of PM2.5 alarm. Device with Wi-Fi is able to
push alarm information to mobile phone.
9-6.Brightness Settings
It is able to set up screen brightness which is a total of 5 brightness.
9-7.Noise Sensor Settings
It is able to enable/disable noise sensor. If enabled, device can be awake from shutdown/ sleep
status by noise sensor.
9-8.Language Settings
It is able to set up language as English or Chinese. (Default is English.)
9-10.About Software
It is able to view device's IMEI number, software version and MAC address.
05/04/2018 Version No. 001 05/04/2018 Version No. 001
Particle Mass Concentration Detector / English
9