Maintenance, Cleaning And Sterilization - Forum Technologies Implant Locator Manual De Instrucciones

7

Maintenance, cleaning and sterilization

7.1. General
• The device does not contain user serviceable parts. The service and
repair should be provided by factory trained service personnel only.
• All objects that were in contact with potentially infectious agents
should be cleaned and disinfected after each use.
Use of agents other than specified in this section may
cause damage to the equipment and its accessories.
7.2. Device cleaning
Before the first use and between treatments the device should be
cleaned using tissue or soft cloth impregnated with aldehyde free
disinfecting and detergent solution (a bactericidal and fungicidal).
7.3. Sensor holder cleaning and disinfection
Before the first use and between treatments the sensor holder should
be separated from the device, cleaned and disinfected using tissue or
soft cloth impregnated with aldehyde free disinfecting and detergent
solution (a bactericidal and fungicidal).
12
No visible impurities should remain on the sensor holder after cleaning
and disinfection process.
7.4. Disinfection and sterilization procedure for sensor
Before the first use and between treatments the Sensor should be disinfected and
sterilized by autoclaving as described below:
The sensor is intended for 10 sterilization cycles maximum
Operation
1 Preparation at the point of use
prior to processing
2 Preparation for decon-
tamination/ preparation before
cleaning
3 Cleaning: Automated
Instructions
No particular requirements
No particular requirements
The sensor is not intended for
automated cleaning
Details and
Warnings