Hergom Sere 100 2C Instrucciones Para Instalación, Uso Y Mantenimiento página 10

2. LIGHTING
COMBUSTION
Follow the instructions below to regulate
combustion:
Move the regulation valve from right to left
•
to provide a greater inflow of air to favour
combustion (FIG. 5).
When lighting, we recommend moving the
•
combustion regulation valve completely to
the left.
It is essential to provide an abundant load of fuel
when lighting. The following loads will depend on
the heat requirement desired.
EIt is advisable to leave the door partially open
to avoid condensation and to keep the glass
clean for some minutes after lighting the fire.
Once the fireplace is working at its normal level
and the chimney has heated up, regulate
combustion by means of the regulation valve.
When the inflow of air is fully closed, combustion
will be slow; when the inflow of air is open,
combustion will be more intense.
For the best performance from your appliance,
place the combustion regulation valve in the
central position.
AND REGULATING
FIG. 5
If the compact fireplace is used in a room together
with other heating appliances that also need air
for combustion purposes, it is advisable to
prepare an additional air intake of outside air to
facilitate the said combustion processes.
The use of one or more heating devices in the
same room reduces the level of available oxygen,
affecting the combustion of the fireplace and
reducing the draw of the chimney.
Actuating the control valve as described in the
previous steps, provides a greater inflow of air for
the combustion process; this provision of air takes
place at the height of the andiron and the upper
part of the glass. Check when loading that the air
inlet at the height of andiron is free from ashes.
Otherwise, clean it to provide a proper
combustion process. This will contribute to the
dual purpose of keeping the glass clean and
facilitating the lighting up process.
ATTENTION! When working, the metal parts of
the fireplace may reach high temperatures.
Protect your hands with a fireproof glove when
touching the said parts.
If you should detect any overheating of the
fireplace caused by:
- Fan breakdown.
- Faulty thermostat.
The fire must be put out to avoid possible damage
to the compact fireplace and to its coating. Follow
these recommendations:
Do not add any more fuel
•
Open the door slightly to let more air in; this
•
will cause the flames to grow and consume
the fuel more quickly but will also cool the
chimney and reduce draw, cooling the
appliance.
The compact SERE has been designed to operate
using intermittent combustion processes.
10