Hergom Sere 100 2C Instrucciones Para Instalación, Uso Y Mantenimiento página 12

Protect your hands with a glove or other
•
insulating material
operation, the opening and closing handle
will be hot.
REPLACING THE POWER SUPPLY CABLE
If the power supply cable has been damaged, it
should be replaced by the manufacturer, via its
Technical Service, or by qualified personnel, in
order to avoid risks.
When installing the compact SERE fireplace,
follow the installation advice below for your
own safety:
1. The base where you are going to place your
SERE must be flat and provide a perfect
seat for your fireplace. The base must be
built using heat resistant materials.
2. The gap in which your SERE fireplace will be
installed must be completely free from
debris and waste materials that may ignite
when the fireplace is working.
3. The inside of the gap where the SERE
fireplace is to be installed will be
appropriately insulated or built of materials
that resist high temperatures.
4. If insulation must be installed inside the
gap, do not cover the ventilation grille.
5. Never wrap
insulation material as this will damage it.
INDUSTRIAS HERGÓM, S.A., rejects any liability
derived from a faulty installation or incorrect
use and reserves the right to alter its products
without prior warning.
Any liability due to manufacturing defects will
be subject to the criteria and verification of the
company's experts and will be limited to the
repair or replacement of its products, excluding
any construction work or damage the said
repairs may cause.
because,
the insert fireplace
during
in
12