Safety Information; Conditions Of Use - Vasco WRX Instrucciones De Uso Y De Montaje

EN – Installation
3. Installation
The unit may only be connected up by a qualified
electrician (in Germany according to BGV A3).
Note
Thermostat and radio receiver need to be
taught-in. Pay special attention to the in-
formation in section 3.7.

3.1 Safety information

Read these instructions thoroughly prior to
installation and commissioning.
After installation, hand over the instruc-
tions to the end consumer.
Warning
Danger of death from electric shocks!
Only install and connect the device in the
de-energized state.

3.2 Conditions of use

Only install thermostat in conjunction with
electrical heaters from the manufacturer's
product range.
When installing in rooms with bath or sho-
wer facilities: comply with protective areas
according to national installation standards
(in Germany DIN VDE 0100-701). Also fol-
low all local regulations.
During installation, a residual-current-ope-
rated protective device (with trigger limit
18
Controller WRX
less than or equal to 30 mA) must be pro-
vided on-site.
If a unit is connected directly to the fixed
electrical installations: incorporate a dis-
connecting device in accordance with the
local regulations for mains disconnection.
Only store and transport the device in the
protective packaging.
3.3 Complaints
Please contact the supplier.
3.4 Technical features (see nameplate)
Corresponds to the standard EN 60730-1,
-2-9
Thermostat batteries: 2 x 1.5 V, type LR6
or AA
Radio frequency: 868 MHz
Performance data radio receiver
Nominal voltage
Output cross section
recommended wire end
ferrules
Maximum switching
capacity
Load rating of contact
Power consumption in
stand-by mode
Insulation type wall
outlet
Protection type wall
outlet
230 V AC
3 x 1.5 mm²
L = 10 mm according to
DIN 46228
1800 W
8 A / 250 V ~ at cos = 1
or
2 A/ 250 V ~ at cos = 0.6
approx. 0.9 W
Protection class I or
Protection class II
IPX4 after proper instal-
lation
05/2019