Thermal Insulation; Packaging, Storage And Transport - Reflex RMB-31-100-P30 Manual De Instrucciones

Accessories / Packaging
Fig.9 presents how to affix the other type of the
brackets:
heat exchanger
1
support
2
6.2.

Thermal insulation

The thermal insulation of the brazed plate heat
exchangers consists of two parts connected by the
latch clamps. It reduces the heat loss and does not
cause unnecessary heating of the room where the
heat exchanger is installed.
The cold insulation of the brazed plate
refrigerant type heat exchangers is made of the
adhesive rubber mat tightly attached to the
surface of the heat exchanger.

Packaging, storage and transport

Heat exchangers should be stored in a sheltered
place, protected against climatic influences and
corrosive agents. During transport and storage
heat exchangers should be protected against
damage and contamination.
For matters not covered
by this instruction manual
please contact the
technical department
of the manufacturer.
EC Declaration of Conformity is available
download on www.reflex-winkelmann.com/en
37
EN