Furrion DV3300S-BL Manual De Instrucciones página 15

Before Operation
Location
1. Choose a mounting location away from humid areas, water sources, appliances or any
equipment that can radiate heat.
2. Select an area on a wall or cabinet which is free from cable, fuel or brake lines. Ensure the
area behind the unit has a vent hole or if it is an enclosed box, it has adequate room around
the rear of the unit for cooling.
3. Ensure when the unit is mounted the wires at the rear are not pressed against the heat sink.
Installing the unit
Before installing the unit, connect the wiring temporarily and make sure the unit and the
system work properly.
Fix the unit with screws according to the following diagram.
1. Remove plastic shell from the front panels of the unit.
2. Fix the unit with 4 pieces of #8 pan head self tapping screws.
3. Put back plastic shell on the front panel of the unit.
SCREW
SCREW
PLASTIC SHELL OF
THE FRONT PANEL
14