Furrion Aurora FDUP43CBR Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Warnings
32. The operation temperature for the unit is
-20°C (-4°F) to +43°C (+109.4°F). The storage
temperature is -33°C (-27.4°F) to +58°C
(+136.4°F). Protect the TV from damage
by the extreme temperature. This is not a
commercial TV.
33. Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.
34. The apparatus should be connected to a
mains socket outlet with a protective earthing
connection.
35. To prevent injury, this apparatus must be
securely attached to the wall in accordance
with the installation instructions.
HOW TO HANDLE THE LED PANEL
Do not press hard or jolt the LED panel. It may
cause the LED panel glass to break and injury
may occur.
If the LED panel is broken, make absolutely
sure that you do not touch the liquid in the
panel. This may cause skin inflammation.
If the liquid gets in your mouth, immediately
rinse and consult with your doctor. Also, if the
liquid gets in your eyes or touches your skin,
consult your doctor after rinsing for at least 15
minutes in clean water.
Possible Adverse Effects on LED Panel: If
a fixed image displays on the TV screen for a
long period of time, it may cause a permanent
disfigurement on the screen with image burn-in or
ghosting. This type of damage is NOT COVERED
BY THE WARRANTY.
Avoid displaying a static picture or a picture
with static elements (black bars, black
borders, logos, etc.) on the TV screen for
more than two hours at a time. Make sure you
change the image on your screen periodically.
If the aspect ratio of the TV is set to 4:3 for
a long period of time, image burn may occur
on the letterboxed area of the screen. Make
sure you change the size of the picture
occasionally.
6
The following symptoms are not signs
of malfunction but technical limitation.
Therefore we disclaim any responsibility for
these symptoms.
LED panels are manufactured using an
extremely high level of precision technology,
however sometimes parts of the screen may
be missing picture elements or have luminous
spots. This is not a sign of a malfunction.
Do not install the LED panel near electronic
equipment that produces electromagnetic
waves. Some equipment placed too close to
LED may cause interference.
Effect on infrared devices – There may be
interference while using infrared devices such
as infrared cordless headphones.
COMPLIANCE
FCC Statement
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the
equipment and receiver.
● Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
● Consult the dealer or an experienced radio/TV
technician for help.
WARNING: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate this equipment under FCC Rules.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido