Service And Technical Problems - Magnat Sounddeck 400 BTX Notas Importantes Sobre La Instalación / Certificado De Garantía

página de 33

/ 33
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

operaTIon

Sound deck controls (front) (fig. 1):

(1) Sensor for remote control and led status display: Please aim at this sensor when using the remote control. The operating

status is indicated by the colour of the LED:

• red: Standby mode

• green: analogue input active

• purple: optical digital input active

• turquoise: coaxial digital input active

• blue: Bluetooth input active, connected to the source device

• blue, flashing quickly: Bluetooth input active, device in pairing mode

• flashing slowly: Mute mode active, device is muted

Sound deck controls (rear) (fig. 2):

(2) mains switch: After installation, use this switch to turn on the device. If the device is not going to be used for a prolonged

period, it should be switched off.

operation with the system remote control (fig. 3):

(7) on/STBy: Switches the device on when it is in the standby mode. If the LED (fig. 1 (1)) does not illuminate, actuate the power

switch ((fig. 2, (2)) located on the rear. Conversely the device can be switched from power operation to the standby mode.

(8) BT paIr: Switches the device to the pairing mode when in Bluetooth operation to establish a connection to a Bluetooth

source device. The blue LED status indicator (Fig. 1, (1)) flashes quickly.

(9) coaX: Switches the device to the digital coaxial input. The turquoise LED status indicator (Fig. 1, (1)) illuminates.

(10) lIne: Switches the device to the analogue stereo input. The green LED status indicator (Fig. 1, (1)) illuminates.

(11) BlueTooTh: Switches the device to the Bluetooth input. The blue LED status indicator (Fig. 1, (1)) flashes or illuminates (see

section System installation - Connecting to a Bluetooth audio source).

(12) opT: Switches the device to the optical coaxial input. The purple LED status indicator (Fig. 1, (1)) illuminates.

(13) Volume: Increases (+) or decreases (-) the volume.

(14) eQ reSeT: Resets the current bass and treble settings (17, 18) to a neutral setting and deactivates the 3D surround sound

function (16)

(15) muTe: Switches the sound on and off.

(16) Surr: Switches the 3D surround sound function on or off.

(17) TreBle: Increases (+) or decreases (-) the volume of high frequencies for manual adjustment of the sound pattern.

(18) BaSS: Increases (+) or decreases (-) the volume of low frequencies for manual adjustment of the sound pattern.