Using Seecode Tube; Battery Charging And Usage; Battery Charging; Battery Information - Seecode HF920 Manual Del Usuario

2.

Using Seecode Tube

2.1 Battery Charging and Usage

2.1.1 Battery Charging

Seecode Tube contains a rechargeable Li-Polymer battery. First-time charging takes about 4 hours. Later-on
recharging needs 2-3 hours. The charging procedure is as follows:
1. Plug the connector of the charger into the USB port on Seecode Tube.
Connect the car charger to the cigarette lighter to start charging.
2.
Icon indicator will blink during the charging. When the icon changes to
is full and you can disconnect Seecode Tube from the power outlet.
You can also use the USB cable to charge Seecode Tube on PC. Charging by using USB cable takes longer than by
using car charger because the output power of the USB cable is smaller than that of the car charger.

2.1.2 Battery Information

Once fully charged, the battery will support continuous talk time up to 10 hours and standby time up to 1000 hours.
When the battery is low, Seecode Tube beeps once every two minutes and there is a message "Battery Low"
displayed on the screen. You can charge the battery as described above.
Note that, over-charging will shorten battery life. If a fully charged battery is left unused, it will lose power over
time. Extreme temperature (either too hot or too cold) will also affect the charging ability, capacity, and lifetime of
the battery.

2.2 Mounting Seecode Tube

Seecode Tube can be easily mounted on the sun visor inside the car by using sun visor plate delivered with Seecode
Tube.
The sun visor plate is adjustable. You can adjust it after mounting it on the sun visor till the OLED screen can
conveniently be seen.
.
Figure 2: Charging
Seecode Tube User Manual
, it indicates that the battery
10