Product Maintenance - Fellowes POWERSHRED 425Ci Manual Del Usuario

Ocultar thumbs Ver también para POWERSHRED 425Ci:
Tabla de contenido

Publicidad

ADVANCED PRODUCT FEATURES
SAFESENSE
Automatically stops when hands touch the paper opening.
SET-UP AND TESTING
2
1
Turn the shredder on to
Touch test area and
activate SafeSense
look for the SafeSense
®
indicator to illuminate

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry.)
TO CLEAN THE SENSORS
2
1
Turn off and unplug
Lift CD flap
shredder
AUTO OIL
TM
Automatically oils the cutters to enhance performance and extend shredder life.
(Auto oil system is only included on cross-cut models - 425Ci and 485Ci)
REFILLING THE OIL
1
Low oil indicator will
To maintain shredder
signal when your reservoir
performance, refill oil
needs refilling
reservoir with up to 12
oz. (355 ml.) of shredder
oil (Fellowes 35250)
• All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and
could ultimately stop running. We recommend that you refill the Auto Oil
• If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain,
remove plug and let oil drain out. Replace plug.
4
®
TECHNOLOGY OPERATION
3
SafeSense
is active and
®
working properly
®
3
Locate Auto-start
infrared sensor
2
3
Once refilled, automatic
oiling will resume
WHEN IN SLEEP MODE
1
In sleep mode
4
5
Dip cotton swab in
Using cotton swab, wipe
rubbing alcohol
away any contamination
from the paper sensors
TM
reservoir as instructed for optimum performance.
Models 425Ci/425i/485Ci/485i
SLEEP MODE OPERATION
Energy saving feature shuts down the shredder after
2 minutes of inactivity
2
3
or
To get out of sleep mode
insert paper
touch control panel
ENGLISH

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Powershred 425iPowershred 485ciPowershred 485i

Tabla de contenido