Installation Instructions - Ebode Light Speaker Guia Del Usuario

Installation Instructions

Step 1: Please read all safety instructions at the start of this
manual.
Step 2: Decide where you would like to add additional bass
to your LightSpeakers and note the zone in which those
LightSpeakers are located.
Step 3: Attach the power cord to the back of your SubWoofer
and plug it into the nearest electrical outlet. Be certain the power
switch on the rear of your SubWoofer is set to the "OFF" position.
Step 4: Pairing your SubWoofer to the LightSpeaker System.
Pairing is the process of "teaching" your transmitter to
recognize your SubWoofer as part of the LightSpeaker system.
It's essential and only takes a couple of minutes.
A) Determine which zone your SubWoofer will be placed into
(See "Setting Up Zones" in your LightSpeaker owner's manual).
B) Set the zone switch on the back of your SubWoofer to either
Zone 1 or Zone 2 depending on which zone it is to be located in.
Low Pass Crossover
80 Hz 100 Hz 120 Hz
+
+
Phase Zone
+
+
0° 180° 1 2
Volume
9