Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
label. Wheels and other accessories running over rated speed can fly apart and cause
injury.
3.
Hold tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord.
4.
Make sure the grinding wheel is not contacting the work piece before the switch is
turned on.
5.
Grinding wheel and guard must be securely attached as described in this operating
manual before connecting the angle grinder to power source.
6.
Grinding wheel must be stored in a dry place.
7.
Always hold the grinder firmly with two hands while working and at all times when it is
running.
8.
Use only quality certified grinding wheels.
9.
Keep hands away from rotating parts.
10. Be careful not to damage the spindle, outer flange and inner flange. Damage to these
parts could result in wheel breakage.
11. When starting the tool (install with a new or replacement wheel), hold the tool in a well
protected area and let it run for one minute to check if the wheel is good or not. Never
start the tool while the operator is standing at in line with the wheel.
12. Know your power tool. Read operator's manual carefully. Learn its applications and
limitations, as well as the specific potential hazards related to this tool. Following this
rule will reduce the risk of electric shock, fire, or serious injury.
13. Always wear safety glasses with side shields. Everyday glasses have only impact
resistant lenses. They are NOT safety glasses. Following this rule will reduce the risk of
eye injury.
14. Protect your lungs. Wear a face or dust mask if the operation is dusty. Following this
rule will reduce the risk of serious personal injury.
6
3.
Do not over tighten it.
Adjusting the Wheel Guard
This tool is fitted with a wheel guard. The closed segment of the guard can be adjusted to
different angles.
a)Pull the quick release lever toward outside so as to enlarge the circular collar of wheel
guard.
b)Turn the wheel guard to a desired angle. Pull back the quick release lever to lock the
guard.
c) Make sure the guard is firmly secured in place. lf the guard is too loose after pulling back
the quick release lever, pull up the lever, properly adjust the nut on the guard and pull
back the lever again.
OPERATION
This angle grinder is designed for the following purposes:
1. Removal of casting burrs and finishing on various types of steel, bronze, aluminum
materials and castings.
2. Beveling and finishing weid seams
3. Grinding of welded sections cut by means of welding.
4. Grinding of synthetic resin bricks, marbles etc.
5. Cutting thin wall tubes and small size metal materials.
CAUTION!
Never cover air vents. They must always be open for proper motor cooling.
To start your grinder:
1. Push the switch button forward to start the tool.
2. For continuous operation, push the switch button forward to the end, press the switch
button at its front and gently release it so that it is locked at "on
To stop your grinder:
"
position.
11
Publicidad
Tabla de contenido
