THOMSON ANT1318 Instrucciones De Uso página 4

G Operating Instructions
Thank you for choosing a Thomson product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• HDTV rod antenna
• Input bandpass filter with USB cable
• 2 mounting clips
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• The product is intended for indoor use only.
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and overheating
and use it in dry rooms only.
• Children should be supervised to ensure that they do not
play with the device.
• Do not use the product in areas where the use of elec-
tronic devices is not permitted.
• Connect the product only to a socket that has been ap-
proved for the device. The electrical socket must always
be easily accessible.
• Disconnect the product from the network using the
power button – if this is not available, unplug the power
cord from the socket.
• Lay all cables so that they do not pose a tripping hazard.
• Do not bend or crush the cable.
• Do not drop the product and do not expose it to any
major shocks.
• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the device in any way. Doing so voids the
warranty.
2
Warning
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the device
yourself. Leave any service work to
qualified experts.
• Do not open the device or continue to operate it if it
becomes damaged.
4. Speci cations
Supply voltage
Rated power
consumption
Frequency band(s)
Active antenna gain
Impedance
Connection
Ambient temperature
5. Startup and Operation
Note
Please note that the number and quality of stations
received may vary depending on the position of the
antenna and local conditions.
5.1 Powering the antenna with the bandpass lter
and the power supply ( g. 1)
• Connect the bandpass filter to the antenna input of the
set-top box or digital TV.
• Connect the coaxial cable from the antenna to the
bandpass filter ('ANT' connection).
• Connect the USB cable of the bandpass filter to a
suitable USB power supply unit (not included) and plug
the latter into a socket.
• Switch on the TV (and the set-top box, if present).
• Check the reception quality. If the reception quality is not
good, adjust the position or angle of the antenna.
100 – 240 V AC / 50 Hz
max. 60 mA
UHF: 470 – 790 MHz
VHF: 174 – 230 MHz
UHF: 6 – 17 dBi
VHF: 4 – 13 dBi
75 ohm
Coax plug
-20 to +40° C