General Features - Seko Pool Kronos 10 Redox Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

General Features

Power Supply 220-240 Vac
Display 4 digits with 7 segments
Bnc connection for probe Redox
Switch 3 position Priming, ON, Stand by
Peristaltic pump flowrate and pressure look at label on product
Measure Range Redox: 400÷999 mV (resolution: 10 mV)
Dosage method ON-OFF ( Set Point adjustable)
Calibration method Redox 1 Point (465 mV)
Switch position
:
1) Priming position "the pump running" (Switch position MOM)
2) Normal position "the instrument measure Redox and dosing. (Switch position ON)
Keep pressed
key for 5 seconds to run calibration menu:
Redox probe: the pump displays C465 press
Displays quality probe ex: C100
Press the button
Keep pressed
key until flashing Setpoint value and press again to increase the value.
After 3 seconds from releasing the key
the range of values is included between 410 and +990 mV with an increase of 10 mV.
When the real measure is less than 400 mV and higher than 999 mV the measure displayed flashes.
3) Stand by position "The pump is stop" (Switch position OFF)
Keep Press
key for 3 seconds to run Setup menu:
Redox setup menu:
Adjust dosage method High ("Hi") or Low ("Lo").
0000138146
Pool Kronos 10 Redox
to stop the calibration.
Pool Kronos 10 Redox
key and wait 60 seconds
the value will be saved and the pump will display mem.
rev. 1.0

Publicidad

Tabla de contenido
loading

Tabla de contenido