Routine Care - BOND MANUFACTURING HYFP50085-3 Manual Del Usuario

USING A LONG MATCH OR LIGHTER
1. Connect propane (LP) cylinder (See above pages).
2. Before lighting, move the lava rocks with a small shovel to allow access to the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are completely
cooled.
3. Locate the burner control knob and make sure it is in the "OFF" position.
4. Wearing heat resistant gloves, position a long lit match or lit long neck
lighter close to the burner ports. DO NOT lean over the burner while
lighting.
5. Push and turn burner control knob to the "LOW" position. The burner
should light within 5 seconds.
6. If ignition does occur within 5 seconds, turn the burner control knob
to "OFF", wait 5 minutes for gas to clear and repeat the lighting procedure. If burner still will
not light, refer to the Troubleshooting Section.
7. Flame height can be changed by adjusting the burner control knob between the "LOW" and
"HIGH" positions.
8. Always check burner flames periodically to ensure proper operation. Flames should be
mostly yellow with some blue for best performance.
TO EXTINGUISH
1. Push and turn burner control knob to the "OFF"
position.
2. Close the LP tank valve.
3. Disconnect the regulator from the LP tank to close the
gas supply when not in use.
4. Make sure that the unit is completely cooled before
touching any of the components or putting on the
cover.

ROUTINE CARE

• Keep your appliance free and clear from combustible materials.
• Visually inspect burner for obstructions, and keep tank enclosure free and clear from
debris.
• After the burner and lava rocks are completely cooled down, use a soft brush to get rid of
the mild stains, loose dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
• Stubborn stains, discoloration and possibly rust pitting can occur from exposure to harsh
outdoor conditions.
• Be careful not let any powder or solvent come in contact with painted or plastic
components as damage may occur.
MAINTENANCE
• Store the appliance in a cool dry place away from direct sunlight.
• Make sure both the gas and the appliance are turned off before changing the battery.
Please refer to the process of inserting battery.
• Protect your appliance with the cover when not in use.
• The propane cylinder must be disconnected and stored outdoors before the appliance can
be stored indoors.
• Use Manufacturer approved or supplied replacement parts and accessories only.
Otherwise this may void the warranty of this product and result in a hazardous condition.
• Please contact the Manufacturer for information regarding replacement hoses,
thermocouples, igniters, lava rocks, etc.
9