FRIEDLAND D942S Libra+ Instalación Y Uso página 4

D942S 48342PL_Ed3 2/1/07
Open the bell push/converter
remove nameplate
Using a ball point pen, press at point shown in
Fig 1 (A) and remove the name plate. If desired,
you can prise apart the two halves of the name
plate and write on the card. Undo the retaining
screw (B) and remove the back of the push.
A
To fit the push/converter battery
Insert the CR2032 coin
cell. Ensure the face
marked '+' is uppermost
(Fig. 2).
Fig. 2
6:31 PM Page 4
Fig. 1
B
Chime switch positions
Mute
To turn the sound off, set switch (C) to position 1.
Flash off
To turn the flashing light off, set switch (C) to
position 3.
Normal operation
For normal operation (sound + flashing light) set
switch (C) to position 2.
Volume control
The volume control is behind the sliding window on
the front of the chime. Initially, set the control to
mid-point. After you have tested your system, adjust
to the desired volume.
Sliding window
Release the catch (D) and slide open the
window (Fig. 3).
D
3
Fig. 3
C