Selecting The Operating Mode - Flex SPR 18.0 Instrucciones De Funcionamiento Originales

SPR 18.0

Selecting the operating mode

 Briefly press the
MODE
selecting the operating mode until the
desired mode is displayed.
The following operating modes are
available:
– Playback of music sources connected via
Bluetooth®
– Playback of music sources connected via
cable
AUX
– Radio reception
FM
– Radio reception
AM
The selection is shown by means of the
corresponding symbol on the left in the
display.
Playback of music sources
connected via Bluetooth®
 Set the operating mode
button for selecting the operating mode.
The symbol flashes.
 Activate the Bluetooth® function of the
device to be connected (mobile phone or
similar) and select "FLEX SPR 18.0" as
the target of the Bluetooth® connection.
For this purpose, follow the instructions
in the device operating manual (mobile
phone or similar).
NOTE
If a password is required, use "0000".
 When the connection is made, the
symbol lights up continuously.
button for
with the
MODE
 The playback of the data from the
external source can be controlled via the
Bluetooth® speaker:
– Briefly press the Playback/Pause
button to start or interrupt the
playback (1.).
– Briefly press the
to the previous or following track (2.).
– To increase the volume, press the
button.
VOL+
– To reduce the volume, press the
button.
VOL-
 To separate the Bluetooth® connection,
press the Playback/Pause
hold until the symbol
The connection is separated.
Playback of music sources
connected via cable
 Set the operating mode with the
AUX
button for selecting the operating
MODE
mode.
 To protect the device, push the external
device under the elastic retaining
strap (1.).
 Release the AUX connector from the
holder and connect with the external
music source (MP3 player or similar) (2.).
 Switch on the external music source and
start the playback.
or button to jump
¶ ·
button and
flashes.
17