Introduction
It is a microprocessor controlled system that is fully DMX-512 and MIDI compatible .The scene setter is a 24
channel DMX-512 and standard MIDI controller. 48 sets of program can be programmed in 4 pages and the
total steps can not be more than 4500. We strongly recommend that you take time to read this manual fully
before you attempt to use the controller.
Warning
1. To prevent or reduce the risk of electrical shock or fire, do not expose this unit to rain or moisture.
2. Often memory clearing may cause damage to the memory chip, be careful not to initialize your unit
frequently to avoid this risk.
3. Only use the recommended AC/DC power adaptor.
4. Be sure to save the packing carton in case you may ever have to return the unit for service.
5. Do not spill other liquids or water in to or on to your amplifier.
6. Be sure that the local power outlet matches the required voltage for your fixture.
7. Do not attempt to operate this unit if the power cord has been frayed or broken. Please route your power
cord out of the way of foot traffic.
8. Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used to
reduce the risk of electrical shock and fire in case of an internal short.
9. Disconnect from main power before making any type of connection.
10. Do not remove the top cover under any conditions. There are no user serviceable parts inside.
11. Disconnect the unit's main power when left unused for long periods of time.
12. This unit is not intended for home use.
13. Carefully inspect this unit for damage that may have incurred during shipping. If the unit appears to be
damaged, do not attempt any operation, please contact your dealer.
14. This unit should be operated by adults only, never allow small children tamper or play with this unit.
15. Never operate this unit under the following conditions:
1. In places subject to excessive humidity
2. In places subject to excessive vibration or bumps
3. In area with a temperature over 45
Cautions
1. There are no user serviceable parts inside this unit.
2. Do not attempt any repairs by yourself; doing so will void your manufacture's warranty.
3. In the unlikely event your unit may require service please contact your nearest dealer.
4. This unit is intended for indoor use only.
5. After having removed the packaging check that the unit is NOT damaged in any way. If in doubt, DON'T
use it and contact an authorized dealer.
6. Packaging material (plastic bags, polystyrene foam, nails, ect.) MUST NOT be left within children's reach,
as it can be dangerous.
7. STOP using the unit immediately in the event of serious operation problems and either contact your local
dealer for a check or contact us directly.
8. DO NOT dismantle or modify the unit.
0
0
C/113
F or less than 2
13
0
0
C/35.6
F