Regarding Lithium-Ion Battery Transportation; Usb Device Connection - HIKOKI M 1808DA Instrucciones De Manejo

English
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
○ If the BSL36B18 is installed in the power tool, the power
output will exceed 100 Wh and the unit will be classifi ed
as Dangerous Goods for freight classifi cation.
Power Output
Wh
2 to 3 digit number

USB DEVICE CONNECTION

PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
<USB charging>
○ Charging a USB device from an electrical outlet
(Fig. 26-a)
○ Charging a USB device and battery from an electrical
outlet (Fig. 26-b)
○ How to recharge USB device (Fig. 27)
○ When charging of USB device is completed (Fig. 28)
NAMES OF PARTS (Fig. 1–Fig. 28)
Battery
Head cover
Name plate
Dial
Motor
Rack portion
Lock lever
Pinion
Collet nut
Collet cone
Base ass'y
Shaft
Switch button
Knob bolt (A)
Fixing nut
Lock pin
Knob bolt (B)
LED light
Switch Panel
Power button
Remaining battery
indicator lamp
Latch
Charge indicator lamp
Removing
Fixing
Socket wrench (8 mm)
Loosen
Tighten
23 mm Wrench
Bit
Collet cone hole
13 mm Wrench
12
Upper end of base
ass'y
Scale
Template guide
Screw
Template
Trimmer guide
Guide pin
Stop screw
Knob bolt (C)
Washer (A)
Body feed direction
Straight guide
Guide holder
Wing nut
Bolt
Wave washer
Washer
Center hole
Nail (rotation axis)
Dust collector
Positioning hole
Protrusion
Screw hole
Knob bolt (D)
Work piece
Rotation of bit
Trimmer feed
Inner peripheral
cutting
(Clockwise)
Outer peripheral
cutting
(Counterclockwise)
Air gun
Battery sliding
grooves
Ventilation holes