HIKOKI M 1808DA Instrucciones De Manejo página 19

TROUBLESHOOTING
WARNING
○ To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source or remove the
battery from the main body before making any adjustments.
○ All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact HiKOKI Authorized
Service Center.
1. Power tool
Problem
Tool doesn't run
Tool suddenly stopped
Doesn't cut well
Remaining battery indicator
lamp is blinking
Remaining battery indicator
on the machine doesn't
match to Multi volt battery
Battery cannot be installed
2. Charger
Symptom
The charge indicator lamp
rapidly fl ickers purple, and
battery charging doesn't
begin.
The charge indicator lamp
blinks red, and battery
charging doesn't begin.
Battery usage time is short
even though the battery is
fully charged.
The battery takes a long
time to charge.
The USB power lamp
has switched off and the
USB device has stopped
charging.
Possible Cause
No remaining battery power
Battery isn't fully installed.
The power is OFF.
Tool was overburdened
Battery or tool overheated
No remaining battery power
The bit is worn or missing teeth.
The collet chuck is loose.
Indicates that the remaining battery charge
is very low.
—
Attempting to install a battery other than that
specifi ed for the tool.
Possible cause
The battery is not inserted all the way.
There is foreign matter in the battery
terminal or where the battery is attached.
The battery is not inserted all the way.
The battery is overheated.
The battery's life is depleted.
The temperature of the battery, the charger,
or the surrounding environment is extremely
low.
The charger's vents are blocked, causing its
internal components to overheat.
The cooling fan is not running.
The battery's capacity has become low.
Charge the battery.
Push the battery in until you hear a click.
Press the power button to switch the power
ON.
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Allow the tool and battery to thoroughly cool.
Charge the battery.
Replace with a new bit.
Firmly tighten the collet chuck.
Recharge as soon as possible.
Refer to the indicator lamp on the battery.
Please install batteries that are multi volt or
BSL18xx series.
Insert the battery fi rmly.
Remove the foreign matter.
Insert the battery fi rmly.
If left alone, the battery will automatically
begin charging if its temperature decreases,
but this may reduce battery life. It is
recommended that the battery be cooled in
a well-ventilated location away from direct
sunlight before charging it.
Replace the battery with a new one.
Charge the battery indoors or in another
warmer environment.
Avoid blocking the vents.
Contact a HiKOKI Authorized Service
Center for repairs.
Replace the battery with one that has
capacity remaining.
Plug the charger's power plug into an
electric socket.
19
English
Remedy
Remedy