Danze DC016028 Instrucciones De Instalación página 5

7
14. Assemble the plastic wall anchor washers (F)
onto the wall anchor bolts (E). The plastic wall
anchor washers (F) should slide over the wall an-
chor bolts (E) and into the hole in the back wall
of the pedestal basin (A).
15. Check the top of the pedestal basin (A) for
level front to back and side to side. Make final
adjustments before assembling the wall anchor
nuts (H) onto the wall anchor bolts (E).
16. Assemble the wall anchor nuts (H) onto the
wall anchor bolts (E) and carefully tighten to se-
cure the pedestal basin (A). Be careful not to
over tighten the wall anchor nuts (H).
17. Install the pedestal column anchor bolt (J)
into the base of the pedestal column (B). Place
the pedestal column anchor washer (K) over the
pedestal column anchor bolt (J). Assemble the
pedestal column anchor cap nut (L) onto pedes-
tal column anchor bolt (J) and carefully tighten
to secure the pedestal column (B).
18. Apply a continuous bead of adhesive caulk
(not included) around the pedestal basin (A) and
wall intersection. Smooth the bead of adhesive
caulk per the adhesive caulk manufacturer's in-
structions. This will assure a water tight seal be-
tween the lavatory and wall.
19. Remove excess adhesive caulk with a dry
cloth.
20. Dampen a cloth with rubbing alcohol and
clean any unwanted adhesive caulk from the
lavatory surface as soon as the wall anchor hard-
ware (D) and pedestal column anchor hardware
(I) has been secured.
21. Complete the faucet and drain connections
per the manufacturer's recommendations.
For installation on the Orrington™ bathroom vanity
1. Install the Orrington™ bathroom vanity ac-
cording to the Installation Instructions provided
with the bathroom vanity.
2. Assemble faucet and drain (not included) in
pedestal basin (A) according to the manufactur-
er's recommendations.
3. Apply a continuous bead of adhesive caulk
(not included) in the groove on the top surface
of the Orrington™ bathroom vanity to assure a
water tight seal between the pedestal basin (A)
and vanity. Spread adhesive caulk slightly with a
putty knife or other flat tool.
8