BQS SOGO SS-18350 Manual De Instrucciones página 14

under the ceiling, less
than 150mm away from
side wall(s)
PARTES
1. On-Off switch
2. Control Panel
3. Remote control
WALL MOUNTING
• According to the drawing (fig1), drill Two holes with the diameter of 8mm and depth of 40mm in the
wall.
• Fix the screws in those holes and hang the heater over those two screws.
OPERATION
Switch on the product using the On-Off switch on
the side.
The product is then in stand-by mode and can be
operated using the control panel or the remote control.
• Button (ON/OFF) = Switches the heater on and
off
• Button (I\II) = Sets the required heat between
low heat output (1000W) and high heat output
(2000W).
• Button Timer = Set switch off timer from 0.5 - 7.5h.
CLEANING & MAINTENANCE
• You must first turn off the appliance and
disconnect its plug from the socket. Do not use
abrasive detergents!
• Clean the body with wet cloth, vacuum cleaner
or a brush!
• You must never submerge the appliance under
water-there is life danger.
• If the appliance should not be used for a
14 español english français portuguese deutsch italiano
Fig 1
1 3
Fig 2
certain period of time it must be secured from
excessive dirt and dust by placing it in its
original package.
• You must never place the hot appliance in its
package!
Note:
Fan heater has in-built safety device that will
turn it off in case of accidental overheating (for
example blocking of the inlet and outlet grating,
slow rotation or no rotation of the motor).
In order to restart the fan heater, you must
disconnect the plug from the socket for a few
minutes (10-30). Remove the cause for the
overheating and then turn the appliance on again.
TECHNICAL SPECIFICATIONS
Model: SS-18350
Voltage / Frequency: 220-240V ~ 50/60Hz
Power: 2000W
2