Tips & Troubleshooting - Gallagher S200 Instrucciones Para La Instalación

TIPS & TROUBLESHOOTING
• Install energizer where it can get plenty of sunlight.
• Keep solar panel clean - periodically use a so cloth with water and a mild
detergent.
• Test voltage on the fence using a Gallagher Fence Volt Meter (G50301).
• Turn energizer off before handling fence or ba ery connec ons.
Symptom
Ba ery
indicator is
solid red
Ba ery
indicator
fl ashes red
Fence Voltage
indicator
fl ashes red
No voltage on
fence
10 10
3E4677 Gallagher S200 Solar Energizer User Manual
Problem
Ba ery capacity is low due
to insuffi cient sunlight.
The energizer will slow
down to use less power
and allow ba eries to
charge.
No ba eries, incorrect
ba eries are connected or
ba eries are damaged.
Output voltage is too low,
due to a high load on the
fence line.
Energizer may have been
damaged by lightning.
Solu ons
• Ensure energizer is ge ng
enough sun.
• Turn energizer off for 3 days
leave in sun to charge ba eries.
• Remove ba eries and use a
12V 1.2A charger to charge
ba eries.
• Connect the correct ba eries.
• Replace both ba eries.
• Check ba eries are OK using
the ba ery check func on.
• Check fence and earth system
for faults.
Check energizer isn't faulty;
• disconnect from fence and
earth
• measure across fence and earth
terminals with a Gallagher
Fence Volt Meter
- if less than 5 kV return
energizer for service
- if more than 5 kV the fault is
with the fence or earth system.