Before Operation; What's In The Box; Prepare Your Remote Control - Furrion FDFS40M4A Manual De Instrucciones

Before Operation

What's in the Box

Thanks for purchasing this Furrion FHD LED
TV. This manual will help you set up and begin
using your TV. First, check the contents of
your box with the parts checklist below:
● FHD LED TV
● Unimote
● AAA battery × 2
● QSG
● Warning Card
● Warranty Leaflet
● Wall-mount screws x 4 (PWM 6x10 mm)
● TV stand
● Screws for TV stand x 4 (BBH 4x15 mm)
Now you can get started!
Prepare your Remote
Control
BATTERY INSTALLATION
1. Open battery compartment cover.
2. Install two AAA batteries.
3. Close the cover of the battery
compartment.
14
NOTE: Use two "AAA" size batteries. The
batteries may last approximately one
year depending on how much the remote
control is used. For best performance, it
is recommended that batteries should be
replaced on a yearly basis, or when the
remote operation becomes erratic. Do not
mix old and new batteries or different types.
BATTERY PRECAUTIONS
These precautions should be followed when
using batteries in this device:
● Use only the size and type of batteries
specified.
● Be sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may cause damage to the device.
● Do not mix different types of batteries
together (e.g. Alkaline and Carbon-zinc)
or old batteries with fresh ones.
● If the device is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
● Do not try to recharge batteries not
intended to be recharged; they can
overheat and rupture. (Follow battery
manufacturer's directions.)
● Please use caution when inserting
batteries to avoid battery damage. If the
spring terminal in the remote control
remains in contact with a side of a
damaged battery it can cause a short
circuit. Never use damaged batteries
as they can become very hot and are
dangerous.