Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Portable Ice Maker___
CLEANING & MAINTENANCE
1.
When performing any cleaning or maintenance to this unit, turn the unit off and be
sure to unplug from power outlet first.
2.
Drain any remaining water out of the water reservoir by unplugging the plastic plug found
on the bottom of the unit. It can be found under the water reservoir.
3.
Wipe the outer surface of the ice maker base with a warm damp cloth and dry with a soft
cloth.
4.
Using a soft damp cloth and diluted solution of water and white vinegar to wipe out the
water reservoir, the liner below the ice pegs, the ice pegs, and the automatic ice shovel.
Leave the transparent lid open to allow the unit to dry completely.
5.
Hand wash the removable ice tray and ice scoop in warm soapy water. Rinse & Dry.
6.
Do not immerse the ice maker base in water or any other liquid.
HELPFUL HINTS
1.
If a power failure occurs, the power cord is disconnected, or the POWER button pressed
during an ice making cycle, small chips may form and lodge in the automatic shovel
causing it to jam. UNPLUG the unit and gently push the shovel to the rear of the cabinet
and gently remove the ice chips. Plug the unit in and press POWER to re-start the cycle.
2.
Make sure the ice tray is sitting properly in the unit or the ice shovel will not be able to
deposit the ice cubes.
3.
If the ADD WATER light stays on after filling the reservoir, turn the unit off and restart it.
4.
If the ice cubes are too large and have pieces sticking to it, the water temperature could
be too cold. Press the SELECT button to change to the S (small) ice cubes.
5.
If all the lights blink simultaneously the water tray may be blocked by an ice cube.
UNPLUG the unit and remove the ice cube. Restart the unit.
8
888-367-7373
___
CLEANING AND MAINTENANCE
AFTER SALES SUPPORT
customer-service@wk-usa.com
Publicidad
Tabla de contenido
