Cleaning Instructions - Centurion Cap 2000 Manual Del Usuario

1 GB ESSENTIAL READING
Centurion bump caps are
ADVICE TO USERS
Bump Caps are to be used when high impact resistance is not essential.
Industrial bump caps are intended to provide protection to the wearer
against the effects of striking his head against hard, stationary objects with
sufficient severity to causelaceration or other superficial injuries.
Materials which may come into contact with the wearer's skin could cause
allergic reactions to susceptible individuals.
STORAGE
These products should only be transported in their original cartons at
ambient temperature (0°C to +30°C). They may be stored in the dark for up
to 5 years.
Storage in direct sunlight, extremes of temperature and in a fashion that is
liable to distort is not recommended.
LIFETIME OF PRODUCTS
These products have been designed to have an in-use life of up to 5 years.
It is recommended that after 5 years the products are destroyed. Excessive
wear and tear can considerably reduce the lifespan of the product.

CLEANING INSTRUCTIONS

Protective products are best cleaned and dried with warm tap water and a
soft cloth. Cleaning with commercial solvents or organic compounds is not
recommended as they cause surface softening and stress relieving with a
loss of physical properties. Check before use that all parts are operational
and undamaged. If in any doubt, contact Centurion.
approved to BS EN 812:2012
WARNING! THIS IS NOT AN INDUSTRIAL SAFETY HELMET
This bump cap does not provide protection against the effects of falling or
thrown objects, or moving suspended loads. It should not be used instead of
an Industrial Safety helmet as specified in EN 397. This bump cap is made
to absorb the energy of a blow by partial destruction or damage to the shell
and the harness, if fitted, and even though such damage may not be readily
apparent any bump cap subjected to severe impact should be replaced.
For adequate protection the bump cap must fit or be adjusted to the size
of the users head. The attention of the user is also drawn to the danger of
modifying or removing any of the original component parts of the bump cap,
other than recommended by the manufacturer. Bump caps should not be
adapted for the purpose of fitting attachments in any way not recommended
by the bump cap manufacturer. Do not apply paints, solvents, adhesive or
self-adhesive labels except in accordance with the instructions from the
bump cap manufacturer.
For further information or for EU/EC (as applicable) Declaration of
Conformities, please visit our web site centurionsafety.eu
PPE Regulation 2016/425: EU/EC (as applicable) Type-Examination by:
British Standards Institution, PO Box 6221, Kitemark Court, Davy Avenue,
Milton Keynes, MK5 8PP, UK
(Notified Body No. 0086)
GB 2